PRINCE PMCK-PM-HP SEAL KIT FOR HAND PUMP

PMCK-PM-HP

PRINCE GEAR PUMP SP20B06A9H2-R

  • FLOW .40 CUBIC INCHES 
  • PSI 3000 
  • SHAFT 5/8" KEYED 
  • MOUNT SAE A 2 BOLT 
  • INLET 7/8-14 UN2B 
  • OUTLET 3/4-16 UN2B
$203.24
In stock
Only 27 left
SKU
SP20B06A9H2-R

The SP20B pump now utilizes self-lubricating thrust blocks that eliminate the need for separate wear plates. They are made from a high strength aluminum alloy with exceptional anti-galling properties. This new thrust block design also incorporates advanced bearings designed specifically for high pressure hydraulic pumps. This new bearing features a robust fluoropolymer PTFE wear surface that yields unsurpassed load carrying capabilities and cavitation resistance even at low speeds and moderate levels of contamination. Also, since the PTFE resin layer is self-lubricating, contamination from bearing wear in high load situations (when no oil film is present) is reduced. This new thrust block design combined with these advanced bearing results in lower friction and less internal oil loss resulting in higher pump efficiencies.

AMERICAN FLAG   MADE IN THE U.S.A.  AMERICAN FLAG

Write Your Own Review
You're reviewing:PRINCE GEAR PUMP SP20B06A9H2-R